![]() Make sure "Canon XXX series" (where "XXX" is your printer's name) is selected in the Print dialog box. ![]() The printer will not print properly if you are using a printer driver for a different printer. If the paper settings do not match the information set for the rear tray, an error code appears on the LCD and message appears on the computer.Ĭheck4 If printing from a computer, delete unnecessary print jobs.Ĭheck5 Is your printer's printer driver is selected when printing? Download it from the web page.Ĭheck3 Make sure paper settings match information set for rear tray. IJ Network Device Setup Utility allows you to diagnose and repair the network status. If you use the printer over a LAN, make sure the printer is correctly set up for network use. Replace the USB cable and retry the printing. There could also be a problem with the USB cable. If printing starts normally, there is a problem with the relay device. If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the computer, and retry the printing. ![]() When the printer is connected to your computer with a USB cable, check the following: Wait until printing starts.Ĭheck2 Make sure printer is properly connected to computer. The ON lamp flashes while the computer is processing data and sending it to the printer. If you are printing large data such as photos or other graphics, printing may take longer to start. Wait until the ON lamp stops flashing and remains lit. The ON lamp flashes while the printer is initializing. When copying ISO/JIS-SCID N2 (printed by inkjet printer) on A4 size plain paper using default settings.Check1 Make sure printer is securely plugged in and press ON button to turn it on.Acoustic Noise is measured based on ISO7779 standard(colour printing) with default setting.Only available for L/4圆/2L/5x7/5x5 Square.and does not take into account warming up time. Copy speed may vary depending on document complexity, copy mode, page coverage, type of paper used etc. Copy speeds are the average of sFCOT and sESAT, ISO/IEC 29183.Optical resolution is a measure of maximum hardware sampling resolution, based on ISO 14473 standard.Declared yield value in accordance with ISO/IEC 29102.Declared yield value in accordance with ISO/IEC 24711 standard.Photo print speed is based on the default setting using ISO/JIS-SCID N2 on Photo Paper Plus Glossy II and does not take into account data processing time on host computer. Document print speeds are the averages of ESAT in Office Category Test for the default simplex mode, ISO/IEC 24734.Ink droplets can be placed with a minimum pitch of 1/4800 inch. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |